#HP P2000 G3 FIRMWARE UPDATE#

To prevent system problems caused by SES broadcasts from third-party storage devices on a SAN, the in-band SES management interface is now disabled by default.ДЄfter a controller crash, the system was power cycled and all configuration settings reverted to factory defaults.ДЄfter the system was power cycled, old replication images are not being recycled.ДЇixed issues with replication operations becoming stalled.Д¬ontroller failback took longer than 60 seconds to complete.Д¬ontroller page fault occurred, related to an internal timer queue issue. Performing a host-channel reset while linear replication was active caused a controller page fault.Д¬ould not create a customer-supplied security certificate if NTP time-zone offset value is non-zero.Д¬ontroller page fault occurred, related to linear snapshot functionality. Network settings were improperly displayed by Management Controller interfaces.

#HP P2000 G3 FIRMWARE UPDATE#

Incorrect 'Maximum Transfer Size' value reported by VPD (Vital Product Data).Д¬ontroller page fault occurred due to running out of non-cache read memory.Д¬ould not use OpenSSL certificate after upgrade to TS252R007.Д¬LI set network-parameters command did not update the link-speed and auto-negotiation settings in relation to the duplex-mode setting.ДЄfter a controller was killed with a PCIE Link fault, invalid status was reported for both controllers. Issue caused by CompactFlash card failure. Event 314 was improperly reported for controller module and expansion module FRUs.Д¬ontroller iSCSI port chip failed with queue full error.Д¬ontroller page fault occurred during failover.

Hp p2000 g3 firmware